Savin SDC306 Instrucciones de operaciones Pagina 45

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 54
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 44
Installation and Operating Instructions
SDC 306 1316BED036-11B-E Date 06/09
- 45 -
11.14 Basic system diagram 14:
2 collector arrays, 1 storage cylinder, auxiliary heating
System 14 has two collector surfaces, one
storage cylinder and one auxiliary heating
function. The control unit regulates the solar
function (temperature difference regulation
for 2 collector arrays) and the auxiliary
heating (thermostat, timeframe). Heat
metering is also possible, e.g. using an
impeller flow meter.
K1 = Collector array 1
K2 = Collector array 2
Information Program Manual operation Basic setting
I I I I
Current collector temperature (E1) Timeframe R2 start Pump A1 off/on Code entry
Minimum collector temperature (E1) Timeframe R2 stop A2 off/on Reset/factory setting
Maximum collector temperature (E1) Maximum temperature of
storage cylinder
A3 off/on Select basic
configuration
Current storage temp. at bottom (E2) Solar circuit Td start A4 off/on Max. collector temp.
Minimum storage temp. - bottom (E2) Solar circuit Td stop Mode yield metering
Maximum storage cylinder
temperature at bottom (E2)
Start temperature, auxiliary
heating
Volume flow
Current storage temp. at top (E3) Set time
DFG/WMM
∗∗
Minimum storage temp. at top (E3)
Glycol type
Maximum storage temp. at top (E3)
Glycol percentage
Current collector 2 temperature (E4) Tolerance for solar yield
Minimum collector 2 temperature (E4)
Code change
Maximum collector 2 temperature (E4)
Current collector flow temp. (E5)
Minimum collector flow temp. (E5)
Maximum collector flow temp. (E5)
Flow rate
Daily yield
Total yield
Displayed only if yield metering is active.
∗∗ Displayed only if yield metering mode is equivalent to 2.
Vista de pagina 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 53 54

Comentarios a estos manuales

Sin comentarios