Savin MLP26 Guia de preparacion descargar pdf (Pagina 31)

Memory Unit TypeB 64MB

Place the controller board on a flat

surface.

Insert the Memory unit to the slot

by placing the notch of the unit to

the projection of the slot, and

then push it down until it clicks.

Match the controller board to the

top and bottom rail using the "T

mark, and then slide it into the

printer slowly until it stops.

Push the handle of the controller

board until it clicks.

Fasten the controller board to the

printer with the two screws.

Note

❒ If the Duplex Unit is not at-

tached, go to step

While aligning the power cord to

the left side groove of the Duplex

Unit, slide the Duplex Unit in un-

til it is connected to the printer.

Attach the interface cable to the

printer.

ZGDX130J

ZGDX250J

ZGDX380J

ZGDX270J

ZGDX240J

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 91 92

Sin comentarios

Savin MLP26 Guia de preparacion Pagina 31